5T manual de-coiler

Max width of raw material :According to the profile

Capacity: 5000kgs

 Inner diameter of coil: 450-600mm

Leveling machine

Main motor power station: 3kw

Upper part 5 shaft, lower part :4 shaft

Punching machine with servo motor

Punching power: 80T

Punch machine with 3 sets molds.

Punching the hole according the drawing

Servo feeder machine (main power 2.2 kw)

roll forming machine

Material thickness range:1.5-2.5mm                                 

Main motor power station: 15kw *2pcs, hydraulic 7.5kw                                   

Forming speed:6-9m/min                                                                     

Quantity of rollers:18 rollers

Shaft Material and diameter: ￠70 mm, material is 45# steel  

Tolerance: 10m+-1.5mm

Way Of Drive: chain sprocket drive

Cutting

1.Cutting motion: The main machine automatically stops and then cutting. After the cutting, the main machine will automatically start.  

2.Material of blade: CR12 with heat treatment

3.Length measuring: Automatic length measuring

4.Hydraulic power 7.5 kw

5.Quantity of blade: 3 sets(Need change by hand)

PLC control system

Automatic length measurement:

Automatic quantity measurement: Computer used to control length & quantity. Machine will automatically cut to length and stop when required quantity is achieved

Control panel: Button-type switch and touch screen

Unit of length: millimeter (switched on the control panel)