Prosessen en komponinten:
3 ton manual de-coiler x1 set
Feeding guide system x1 set
Main roll forming machine x1 sets
Hydraulic cutting and punching x1 sets
Hydraulic station x1 set
PLC Control system x1 set
Run-out table x1 set
Parameters en spesifikaasjes:
- 1. Wend wêzeldecoDeer
Capacity: 3 tons
Diameter berik: 300-450mm
Manier fan de-coiling: passyf
- 2. Feedingneiidesystem
Input width adjustable，Guiding system consists of several rollers, and the width between them could control by the manual rollers.
- 3. Eninlyforming system
(1) Matching materiaal: Galvanized of aluminium
(2) Materiaal dikte berik: 0.6-1.0mm
(3) Forming snelheid: 0-40m / min, gjin stop cutting
(4) Haadkrêft: 5.5KW, mei reduksje
(5)Quantity of roller：10-13 rollers
(6)Shaft Material and diameter: ￠50 mm, material is 40# steel
(7) De manier fan riden: Ketting oandreaun
(8)Controlling system: PLC,The target piece’s length is adjustable and digit of it can be adjusted. Computed mode has two modes: automatic and manual one. The system is easy to operate and use.
(9) Spanning: 380V/ 3fase/ 50 Hz
(10) Servo motor: shanghai Zoncn
(11) Materiaal fan foarmjende rollers: 40 # stiel coated mei chromed
(12) Cutting: Materiaal fan cutter blade: Cr 12 mal stiel mei quenched behanneling, HRC 58-62 ℃,
Tolerânsje fan lingte: +/- 1,5 mm
Lengtemjitten: Automatysk lingtemjitten
Kontrôle: troch it ynstellen op it PLC-systeem
- 4. Receivingtabde1 set
