If you’re speccing suspended ceilings week in, week out, you quickly realize one thing: reliability beats flash. The T ceiling fut furring grid roll forming machine is built with that in mind—an honest, fully automatic line that turns coils into Main Tee, Cross Tee, and Wall Angle sections with minimal fuss. I’ve seen lines claim “plug and play.” This one, to be honest, comes unusually close.
Demand for acoustic and demountable ceilings is rising in offices, healthcare, and cleanrooms. Shorter build cycles mean roll-form lines must switch profiles fast, hold tight tolerances, and run quieter. Many customers say the killer feature is predictable length accuracy—less rework onsite, less scrap. It seems obvious, but not every machine nails it.
The T ceiling fut furring grid roll forming machine comes as a coordinated trio: Main Tee machine, Cross Tee machine, and Wall Angle machine. Feed the coils, set the recipe, and the PLC synchronizes punching, forming, and cutting. Actually simple once dialed in.
| Parameter | Typical range (≈) |
|---|---|
| Coil material | GI (ASTM A653) / PPGI / Aluminum (EN 485) |
| Thickness | 0.3–0.6 mm (real-world use may vary) |
| Yield strength | 240–350 MPa |
| Line speed | 20–40 m/min (profile and punching dependent) |
| Length tolerance | ±0.5 mm typical |
| Stations | 12–18 stands |
| Cutting | Hydraulic flying or stop-cut |
| Power | 15–30 kW (total installed) |
| Controls | PLC/HMI: Siemens or Mitsubishi |
| Service life | ≈10–15 years with proper maintenance |
Offices, hospitals, airports, education, retail, cleanrooms (pharma/electronics), and hospitality fit-outs. The T ceiling fut furring grid roll forming machine particularly shines on multi-profile programs where Main Tee, Cross Tee, and Wall Angle must match perfectly.
| Feature | YingYee | Vendor A (import) | Vendor B (retrofit) |
|---|---|---|---|
| Speed | Up to 40 m/min | 30–35 m/min | 20–30 m/min |
| Thickness range | 0.3–0.6 mm | 0.35–0.6 mm | 0.3–0.5 mm |
| Changeover | Cassette options | Manual shimming | Limited |
| Standards | ASTM C635/C636, EN 13964 | ASTM alignment | Local spec |
| Support | Remote + onsite | Remote only | Onsite, limited parts |
One Middle East fit-out supplier ramped to 24,000 m² of grid in 18 days—two shifts, two operators per line. Scrap dropped under 1.5% after recipe tuning. Another client in Eastern Europe liked the quieter run; “our neighbors stopped complaining,” they joked. Address for traceability: Room B1106, Zhongliang Plaza, No.345 Youyi North Street, Xinhua District, Shijiazhuang, Hebei.
Final thought: the T ceiling fut furring grid roll forming machine isn’t flashy. It’s the steady one that delivers Saturday after Saturday when the site needs tees Monday morning.
