Inneal doras còmhla-rolair le structar cruaidh

 

Processes and components:

3 ton manual de-coiler                             x1 set

Feeding guide system                              x1 set  

Main roll forming machine                         x1 sets

Hydraulic cutting and punching                      x1 sets 

Hydraulic station                                  x1 set

PLC Control system                               x1 set

Run-out table                                     x1 set

 

Parameters and specification:

1. 1. B’ àbhaist dhomhlsgeadTha aner

Capacity: 3 tons 

Trast-thomhas raon: 300-450mm

Dòigh dì-choilich: fulangach

2. 2. Fedingguidesystem

Input width adjustable，Guiding system consists of several rollers, and the width between them could control by the manual rollers.

3. 3. Agusinlyforming system

(1)Matching material: Galvanized or aluminum

(2)Material thickness range: 0.6-1.0mm                 

(3)Forming speed: 0-40m/min, no stop cutting

(4)Main power: 5.5KW,with reducer            

(5)Quantity of roller：10-13 rollers

(6)Shaft Material and diameter: ￠50 mm, material is 40# steel

(7)The way of driving:Chain driven

(8)Controlling system: PLC,The target piece’s length is adjustable and digit of it can be adjusted. Computed mode has two modes: automatic and manual one. The system is easy to operate and use.

(9)Voltage: 380V/ 3phase/ 50 Hz

(10) Servo motor: shanghai Zoncn

(11)Material of forming rollers:40#steel coated with chromed

(12)Cutting :Material of cutter blade: Cr 12 mould steel with quenched treatment，HRC 58-62℃,

Tolerance of length: +/- 1.5mm

Length measuring: Automatic length measuring

Control: by setting on the PLC system

4. 4. Receivingtaban1 seata